Screwed harness bar for Alfa 4C
We can now do a complete reconstruction for your Alfa 4C. Everything including road approval!
We use high-quality Recaro seats. You can try the seats here in house. The driver side can be adjusted in height/tilt and length. The co-driver side is built fix in length, height and tilt can be adjusted too.
We will remove the original harnesses and replace them by 6-points harnesses which are very easy to handle with. The lap belt is 50 mm wide and the shoulder belt 50 mm. Airbag and belt tensioner system stay in operation.
In the engine compartment, a shoulder strap strut is mounted on which the shoulder straps are looped. For this purpose, the partition is provided with four minimal openings.
The conversion can always be built back to its original state.
Sample of conversion includes:
- two Recaro seats with seat substructure
- two Schroth harnesses (4 points approved by ECE- & FIA)
- harness bar made by SRT (near the engine)
- Airbag and belt tensioner kit to bridge the system
- all needed work
- DTC acceptance with official report for mutation on the road traffic office
Price for complete conversion: from CHF 5’970.-
38 mm Durchmesser Hauptbügel, 40 mm Durchmesser Hauptbügel, 45 mm Durchmesser Hauptbügel, 50 mm Durchmesser Hauptbügel